Details of Questions ( 13 + 15 *2 = 43)
ENGG381-14A Engineering Statistics
Assignment 5 (15 Questions done twice by two people, i.e. 30 answers given in separate files)
-TASK A: SPC for Rod Thickness (7 Questions done twice by two people i.e. 14 Questions)
-TASK B: SPC for Pigment Manufacture Process (4 Questions done twice by two people i.e. 8 Questions)
-TASK C: Statistical Engineering Algorithm for truckpull2014.mtw Truck Pull (4 Questions done twice by two people i.e. 8 Questions)
Description of work:
A plant manufactured approximately 12,000 connecting rods per day for use in an engine assembled
in the plant. The rod, illustrated above, connects the piston (at the small or pin end of the rod) to the
crankshaft (at the large or crank end of the rod). The plant received forged blanks and machined the
rods in a large number of process steps.
Management identified the rod line for a variation reduction project because the overall scrap cost
was greater than budget. The yearly scrap cost was excessive, and the scrap rate had been 3.2% over
the previous four months. Looking at scrap records, the team found that scrap occurred at several
stages in the process and for several reasons. The results showed that 65% of the scrap occurred at a
grinding operation. At this operation, the team discovered that about 90% of the scrap was due to
rods with their crank end thickness less than specification. The team focused their attention on
reducing variation in rod thickness. Their first step was to set up control charts to see whether the
grinding step produced rods with a stable crank end thickness.
The worksheet contains the output from the first five days of charting. Thicknesses were recorded
from subgroups of 5 consecutive rods chosen at 8 times spread through each day. As in normal
operation, each rod was measured at 4 positions (white circles in figure); the worksheet contains their
mean thickness as a deviation from 0.900 inches in thousandths of an inch (i.e. mil). In that scale the
specification range is [10, 60] mil and in practice if any of the 4 deviation measurements was less than
10 mil the rod would be scrapped. Those with any over 60 mil were reworked.
All software output files and data files given in separate .zip files.
Another 13 questions + above 15 question details are as per the attachments.
Thanks,
They have a magnificent team. These people are always kind and willing to listen to your concerns or issues. Better yet, your assignment is always ready before the time, they usually send you a draft to double-check before they finalize your paper.
Delivering a high-quality product at a reasonable price is not enough anymore.
That’s why we have developed 5 beneficial guarantees that will make your experience with our service enjoyable, easy, and safe.
You have to be 100% sure of the quality of your product to give a money-back guarantee. This describes us perfectly. Make sure that this guarantee is totally transparent.
Read moreEach paper is composed from scratch, according to your instructions. It is then checked by our plagiarism-detection software. There is no gap where plagiarism could squeeze in.
Read moreThanks to our free revisions, there is no way for you to be unsatisfied. We will work on your paper until you are completely happy with the result.
Read moreYour email is safe, as we store it according to international data protection rules. Your bank details are secure, as we use only reliable payment systems.
Read moreBy sending us your money, you buy the service we provide. Check out our terms and conditions if you prefer business talks to be laid out in official language.
Read more